Guntermann-drunck DL-MUX4 User Manual download pdf (Page 69)

Configuration

G&D DL-MUX4 · 25

English

How to change the settings of the scancode set:

(De)activating the switching

A computer, which is connected to the KVM switch, can be accessed by pressing

either the

buttons at the device or configured hotkeys (select or step keys). It can also be

accessed via a

serial interface.

After you purchased and activated the DevCon function, you can use the Config Panel

web application or SNMP to switch to the

IP protocol.

If desired, the switching possibilities can be limited.

Setup mode

1. Press Hotkey+Backspace (default: Ctrl+Backspace) to activate the setup mode.

If the hotkey delay is activated, press the key combination during the adjusted time

(default: 7 seconds).

2. Press one of the setup keys listed below to activate a particular scancode set:

2  activate scancode set 2 for PS/2 keyboard inputs

3  activate scancode set 3 for PS/2 keyboard inputs

3. Restart the KVM switch.

After the restart, the keyboard is being initialised and the selected scancode set is applied.

Config Panel

1. Use the tree view to click on KVM switches > [All switches].

2. Right-click the KVM switch and click on the Configuration entry in the con-

text menu.

3. Click the General tab.

4. Use the field Scancode Set to select between the following options:

Set 2  activate scancode set 2 for PS/2 keyboard inputs

Set 3  activate scancode set 3 for PS/2 keyboard inputs

5. Click OK to save your changes.

6. Restart the KVM switch.

After the restart, the keyboard is initialised and the selected scancode set does apply.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 83 84

No comments

Guntermann-drunck DL-MUX4 User Manual Page 69